Induction Loop Products - Overview

A functional induction loop system / hearing loop system that provides a genuine benefit to its users and fulfils all the requirements of the international performance standard consists of 5 main components.

Ampetronic manufacture and supply a complete range of products to satisfy the requirement of these 5 components which are listed below with explanatory notes, if you can’t find what you're looking for or require a bespoke solution please contact us:

1. An audio source (such as a microphone)

An induction loop system will only produce a quality and intelligible audio signal if the source sound is captured correctly. The sound may be a voice, in which case a microphone is required, or an audio signal such as a TV or mixing desk which can be captured using a line connection.

Counter induction loop microphonesInduction loop amplifier adaptorsMicrophone pre-amplifiers

2. An Induction Loop Amplifier (Driver)

An induction loop / hearing loop amplifier is usually referred to as a ‘driver’ and is at the heart of an Induction Loop system, they should not be confused with a voltage drive speaker amplifier as they are specifically designed to drive current into the loop cable. Ampetronic provide the largest selection of specialised induction loop driver solutions on the market, each designed to suit a specific application.

Room perimeter hearing loop amplifiersInduction loop metal loss control systemslow spill hearing loop systems
counters 09Intercom and help point induction loopsVehicle induction loop drivers
Wall mounted tamper proof ampsLift or elevator induction loopsDomestic TV room amplifiers

System expansion components

In order to drive complex Multi-Loop systems, or combine induction loop drivers to cover very large or unusually shaped areas, it is often necessary to use phase shifters and/or current transformers. Ampetronic provide the necessary ancillary components to enable this type of system design; however it is recommended that you contact us for technical advice.

 90 degree magnetic field phase shifterHearing loop amplifier transformerscombiners 18

3. The copper ‘loop’ cable and fitting accessories

The most obvious component of an Induction Loop system is the cable that is used to form the actual ‘loop’ or ‘loops’. Ampetronic induction loop cable is available as wire for installation around the edge of rooms, in ceilings or in conduit, with a protective shielding for burial in concrete screed, or as a flat tape for installation under carpets or other floor coverings. It is always advisable to use Ampetronic’s Warning Tape with flat copper tape which not only adheres it to the floor, but also warns carpet fitters about the loop so they don’t accidentally cut it.

Flat copper tape wire and cable Adhesive warning tapeProtective PVC extrusion

4. Signage and notification

An essential part of any induction loop system is adequate signage. Unless a potential user already has their hearing aid set to the telecoil setting, which is highly unlikely, then a loop system is both invisible and inaudible. Nobody will use it if they don’t know it’s there. Signage should be placed at all entry points and on room walls.

Induction loop signsInduction loop sign window stickers

5. Receiver & testing equipment

All induction loop systems should be supplied with equipment to allow the operator to regularly listen to the loop to ensure that it is switched on and to check that it operating as intended. Loop receivers can also be handed out to hearing impaired users who do not have telecoil enabled hearing aids.

Induction loop receiversInduction loop system testing equipment